Introduction

The MMA7361 from Freescale is a very nice sensor with easy analog interface. The MMA7361 is a 3.3V part and outputs an analog voltage for each of the three outputs. This voltage is in ratio to the measured acceleration and to the supply voltage (ratiometric). It has selectable sensitivity by dip switch.  You will need some extra hardware to convert this analog signal to a usable digital one.  The Arduino is really good option for it.  This break board is especially designed for Arduino which has 3 JST connector that can be easily plug into our IO/Sensor expansion board.

Specification

• Voltage:3.3-8V
• Selectable sensitivity:±1．5g/6g
• Low power:500μA @ measurement mode，3μA @standby ；
• High sensivity: 800 mV/g @ 1.5g；
• Interface:Analog Output
• Low pass filter
• Size:23x26mm
• Weight: 5 gram

Documents

• Datasheet
• Tom Igoe's online tutorial using the MMA7260Q

Shipping List

• MMA7361 (1 Unit)
• Analog Cable (3 units)

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:

  reset verification