Introduction

This is a4.8-46V, 2A Dual Motor Controller which is the revised version of the DF-MDV1.0. Its performance has been improved greatly. It can bear larger current due to the increased haetsink dissipation. It is easy to control, using LGS's outstanding high-power motor driver chip, the L298N. This chip allows for direct drive of two bi-directional DC motors, and incorporates high-speed short diodes for protection. Drive current up to 2A per motor output. The driver uses a broad-brush design to reduce wire resistance.

 

Specification

• The logic part of the input voltage: 6 ~ 12V
• Driven part of the input voltage Vs: 4.8 ~ 46V
• The logical part of the work current Iss: 36mA
• Drive part of the operating current Io: 2A
• Maximum power dissipation: 25W (T = 75 degree Celsius)
• Control signal input level:
• High level: 2.3V = Vin = Vss
• Low:-0.3V = Vin = 1.5V
• Operating temperature: -25 degree Celsius ~ +130 degree Celsius
• Drive Type: Dual high-power H-bridge driver
• Module Size: 47 mm × 53mm
• Module Weight: About 29g

 

Documents

• Wiki Doc
• Schematics

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:

  reset verification