Introduction

This LCD module uses a 128x64 liquid crystal display that support Chinese character ,  English characters and even graphics. It is suitable for interactive work with Arduino.

It features a backlit control, pallerlel or serial control, contrast adjust. It can be connect to our interface shield via IDC6 socket and cables.

The LCD is shipped in Pallelel mode in default.  The R9 is used to set the interface mode. To switch to SPI mode, the R9 resistor need to be moved to R10

Specification

• Power Supply: 4.5～5.5V
• Micrcontroller：ST7920
• Resulution：128×64
• Display color：blue lit with white char
• View angle：170 degree
• LCD module：STN
• Control interface：8/4 bits Pallelel  (Default) or 3 bits serial (SPI)
• Module size:93x70x22mm
• Visuable size:73x39mm

Documents

• Wiki Doc
• Arduino library v1.0 for serial mode
• Arduino library v1.0 for parallel mode
• Setup LCD12864 screen in SPI mode with Arduino
• Schematic

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:

  reset verification