Introduction

This is a really easy use prototyping plate. Basically you can put everything from Arduino board to sensors, even a motor on top of it.  It fits M2-M3 screws.

NOTE: This product does not ship with the board shown above.  Please check the shipping list below for reference.

Specification

• Size:170x150mm
• Slot size:3mm
• Total weigt:350g (including all screws)

Shipping List

• Prototyping Plate (1 unit)
• M3 screw set (50 units)
• M3 * 10 Hexagonal Copper standoffs (10 units)
• M3 * 10 Hexagonal Nylon standoffs (10 units) 
• M3 * 20 Hexagonal Nylon standoffs (10 units) 
• M3 * 30 Hexagonal Copper standoffs (10 units)
• M3 * 50 Hexagonal Copper standoffs (10 units)

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:

  reset verification