2A Motor Shield For Arduino
2A Motor Shield For Arduino

2A Motor Shield For Arduino

Product Code: DRI0009 Brand: DFRobot
Qty : Price :
2-4 $15.80
5-9 $15.00
10+ $14.80
Reward Points: 16

- +


 Add to Cart

http://www.dfrobot.com/image/data/DRI0009/L298N datasheet.pdfIntroduction

This  DFRobot Arduino Compatible Motor Shield (2A) uses L298P chip which allow to drive two 7-12V DC motors with maximum 2A current. This shield can be directly mount onto standard Arduino Duemilanoveand Arduino Mega.
The speed control is achieved through conventional PWM which can be obtained from Arduino’s PWM output Pin 5 and 6. The enable/disable function of the motor control is signalled by Arduino Digital Pin 4 and 7. The Motor shield can be powered directly from Arduino or from external power source. It is strongly encouraged to use external power supply to power the motor shield.
  • Logic Control Voltage:5V (From Arduino)
  • Motor Driven Voltage:6.5~12v(VIN Power Supply),4.8~35V (External Power Source)
  • 2 way motor drive
  • Logic supply current Iss:≤36mA
  • Motor Driven current Io:≤2A
  • Maximum power consumption:25W(T=75℃)
  • Up to  2A current each way
  • Pin 4,5,6,7 are used to drive two DC motor 
  • Support PWM speed control 
  • Support PLL advance speed control
  • Size: 55x55mm



  • Arduino UNO 
  • Arduino UNO R3
  • Arduino Mega 1280/2560



Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:

  reset verification

You may also like..
Clover Light
6 DOF IMU Shield
Digital Vibration Sensor
CO2 Sensor (Arduino compatiable)
littleBits Base Kit
Arduino Leonardo (+headers)
Screw Terminal 3.5mm Pitch(2-Pin)
Flange Nuts
Romeo V2-All in one Controller