Three Wire connection from Heart Rate Monitor V 1.0 to DFRduino UNO R3:
dwyoung 2017-08-19 06:44:47 6970 Views1 Replies Three Wire connection from Heart Rate Monitor V 1.0 to DFRduino UNO R3: 3 wire cable has 1 of 2 connectors that are not compatible.
Demonstration layout shows three individual wires, each with a commercially shaped conductor on the end. That was not delivered and I could not find these wires in the catalog.
I was delivered a good looking 3 wire cable. Do I force withdrawal from the small black rectangular plastic plug?
This is my 1st Arduino, Wiring
We can all laugh now I love the truth
Demonstration layout shows three individual wires, each with a commercially shaped conductor on the end. That was not delivered and I could not find these wires in the catalog.
I was delivered a good looking 3 wire cable. Do I force withdrawal from the small black rectangular plastic plug?
This is my 1st Arduino, Wiring
We can all laugh now I love the truth 2017-08-19 06:59:16 Maybe I see one answer, LHI , apply Light Hot Iron to get the wire out of the connector. Any tricks inserting the new wire into the UNO R3 receptacle with good conductivity and mechanical stability? I do not see any screws to hold the wire, so the termination of that wire can only be done with good quality control, yes? All this detail is somewhere for the beginner right? Yes, it is time for all of us to laugh again! dwyoung
dwyoung 