Page 6 of 6

Re: DFRobot Technical Support Forum is Online!

Unread postPosted:Tue Mar 16, 2021 7:21 am
by 347945801
You can try another power supply to supply power to the display, these masters may not be able to provide such a large current.

Re: DFRobot Technical Support Forum is Online!

Unread postPosted:Tue Mar 16, 2021 5:52 pm
by m.hirschberg1
Dear DFR tech support,

I recently bought a DFR0528 Raspberry Pi Hat.
I'd like to update it's firmware, from v1.2 to v1.3.

How can I do this?
What is required?

Best regards,

mimi040

Re: DFRobot Technical Support Forum is Online!

Unread postPosted:Sun May 09, 2021 9:50 am
by mertbora723
Hello,

Recently, I bought a "Gravity: BNO055+BMP280 intelligent 10DOF AHRS" Sensor to use with my Teensy 3.6. It shows up in the i2c scanner but the example read_data code for bno055 says bno not detected.
How can I fix this problem? BMP280 works fine with Teensy 3.6.

Thanks

Re: DFRobot Technical Support Forum is Online!

Unread postPosted:Fri Jul 02, 2021 6:39 pm
by quigg
Hello!

We recently purchased the HPS-3D160-L LiDAR sensor and am following your tutorial to set it up on my machine. I am using Windows 10 but am receiving a .NET error when I try to install the driver. The error message is:
.NET Framework 4.6.1 or a later update is already installed on this computer.
Any suggestions on this?

Also - I have the ethernet model with an ethernet / USB adapter, should I expect any problems with this setup?

Thanks so much!