Page 1 of 1

Need a help

Unread postPosted:Mon Aug 12, 2019 6:39 pm
by ruspelirzi
Hi!

I followed the Wiki on how to use this motor driver. Double checked on oscilloscope on the servo pulse timing.

Here is the symptom:
1) Individual controlling CH1 and CH2 no issue - works as specs

Kindly advise whether is the firmware of the board need to be updated?

Thanks.

Re: Need a help

Unread postPosted:Wed Aug 14, 2019 5:52 am
by nana.wang
Hi thanks for your support.
Could you please offer the SKU no. for our reference? Or you mean CH1 and CH2 in Vortex?