Page 1 of 1

Gravity IoT Starter Kit for micro:bitKIT0138 : red and black cables inverted - no connexion

Unread postPosted:Sun Jun 16, 2019 1:21 pm
by aplennevaux
hi!
I ordered the Gravity IoT Starter Kit for micro:bit (KIT0138)
When doing the initial printed tutorial , i'm stuck trying to connect to the Wifi network.
It keeps displaying the cross sign.
When i look at the cables, the part connected to the Expansion shield is ok, but the other side, connected to the Gravity board, has the black and red cables inverted, in comparison with what is printed in the handbook.
See this photo:
Image

In that case, it seems to me it is a factory mistake and I should receive a properly made cable, but I don't see any other support than this forum.
Please advise !

Re: Gravity IoT Starter Kit for micro:bitKIT0138 : red and black cables inverted - no connexion

Unread postPosted:Mon Jun 17, 2019 1:46 am
by nana.wang
Hi, thanks for your support and sorry for inconvenience caused.
Could you please provide the photo link for reference?
The photo uploaded cannot be checked now.
Please do not afraid, it will be alright.