By nahidalam
#1575
Hi All,
Did anyone use Cherokey 4WD Mobile Robot?
The product page says it is compatible with Arduino UNO etc. How do you attach an Arduino here?
By nahidalam
#1578
So I assembled the kit, connected wires & put the sample code in the wiki. But the motors are not moving. Here is what I did.

-GND & VCC from the battery pack is connected to the power in (beside on/off switch). Turn on the switch turns all the LED on. so I think no issue with the power source.
-two wires from each motor are connected to M1, M2, M3, M4
-arduino power connected
-D4-D7, RXD->RX, TXD->TX from the board to arduino connected

But the car is not moving. Anything else I need to do? Where do you press key to control forward/backward etc?