By nahidalam
Hi All,
Did anyone use Cherokey 4WD Mobile Robot?
The product page says it is compatible with Arduino UNO etc. How do you attach an Arduino here?
By nahidalam
So I assembled the kit, connected wires & put the sample code in the wiki. But the motors are not moving. Here is what I did.

-GND & VCC from the battery pack is connected to the power in (beside on/off switch). Turn on the switch turns all the LED on. so I think no issue with the power source.
-two wires from each motor are connected to M1, M2, M3, M4
-arduino power connected
-D4-D7, RXD->RX, TXD->TX from the board to arduino connected

But the car is not moving. Anything else I need to do? Where do you press key to control forward/backward etc?