Page 1 of 1

DFR0524 display settings

Unread postPosted:Tue Apr 07, 2020 9:20 pm
by chris.smith
I have two questions. First I'm trying to get the display working on another linux SBC (Coral Board). I need linux cvt mode line for the display. I've tried many settings and there is always some issue or bad flicker. The screen will work fine on a Windows machine so I know there is no hardware issue. The display doesn't seem to be properly setup for EDID config so can't query it that way.

Second how does one adjust the brightness through software as specified on the wiki?

Re: DFR0524 display settings

Unread postPosted:Wed Apr 08, 2020 1:17 am
by nana.wang
Hi Chirs,
thank you for your support and contact.
We are checking it and will feed you back ASAP.

Re: DFR0524 display settings

Unread postPosted:Wed Apr 15, 2020 2:52 am
by nana.wang
Hi, we checked it out.
We are sorry that the brightness can not be adjusted. Please note it.

Re: DFR0524 display settings

Unread postPosted:Fri Jun 18, 2021 2:13 pm
by u5eiv8vz
was angry, he climbed to the roof and jumped down the chimney. los angeles escort girls

Re: DFR0524 display settings

Unread postPosted:Thu Oct 21, 2021 7:08 pm
by meleknistra
With all the electronics i buy i always make sure there is a decent customer service available. It is one of the most important requirements when it comes to expensive purchases. We also had an issue recently so i called assurance wireless phone number straight away. Everything was solved in few minutes.