Page 1 of 1

ANALOG SOUND LEVEL METER - MOVE MICROPHONE

Unread postPosted:Mon May 10, 2021 7:40 am
by tranphuc52020
Dear all,

We are using your analog sound level meter in an embed equipment and therefore we need to protect the card. Due to the design, it is quite hard to have a protection that is lower than the microphone, which is why we would like to move it a little. Should everything be OK this way? Or is there any underlying complexity that we don't know and should prevent us to move the mic?

By the way, many thanks for your cards, very useful!
Many thanks,
Victor.

Re: ANALOG SOUND LEVEL METER - MOVE MICROPHONE

Unread postPosted:Wed May 12, 2021 6:41 am
by 347945801
I don't know how you will move the microphone, but I don't recommend you to use the flying line method, which will increase some unnecessary noise.