[Marcox81]

Hi @all.

I've got the OBD2 KIT #1; all seems ok but the OBD doesn't connect;
I plug the usb or car AC > OBD blink blue for a second then stop on red > on the OLED:
"SDHC 8GB
OBD X
dfrobot X"

The OBD adapter is the "I2C Adapter"  and I've connected it to pin 4 (+) and 6 (-) of ICSP;
yellow > TX1; white > RX0 on Arduino

The TX led on arduino blink every 2 second but OBD is still in "X"

Any help?

Many thanks

[Marcox81]

Updated config and changed in nanologger.ino the line 268 to "recover();" as suggested by Stanley.

Now I've another problem, the arduino connect to my Toyota yaris, but don't connect to my Ducati wirh Marelli ECU (IAW5AM), that use the ISO9141-2 protocols

This protocol is supported from the OBD, but it doesn't.

Any help please!

[Vaso]

[quote="Marcox81"]
Updated config and changed in nanologger.ino the line 268 to "recover();" as suggested by Stanley.

Now I've another problem, the arduino connect to my Toyota yaris, but don't connect to my Ducati wirh Marelli ECU (IAW5AM), that use the ISO9141-2 protocols

This protocol is supported from the OBD, but it doesn't.

Any help please!
[/quote]
Some Info about Ducati wirh Marelli ECU (IAW5AM):

Standard KWP2000, ISO 14230-4
Speed 38400bps
Startup sequence auto-reply to the ECU on power up a certain ISO hex code (55 B0 80 80 80 85) at a specific timing interval

Marcox81, did you solve your problem?

[Marcox81]

not yet.

Atm I can retrieve data, but in wrong format.
example:
RPM effective: 2000
Arduino: 334

[fblogin2016.com]

Thanks for sharing. I hope it will be helpful for too many people that are searching for this topic.
fb login

[rosymalhotra9]

Impressive articel and wanna say thanks a lot for providing some info about OBD Communication. These are similar problems which can be happen any moment. thanks a lot for the perfect way to get rid from it. Thanks a lot. Meet Russian Amritsar Escorts

[sabrinagilbe]

Thanks for the update and quick reply. Works like a charm! I'll be sure to keep an eye on this thread.