By antonio88m
#6484
I would like to know if you offer also the service of pcb assembling.
By Leff
#7001
Hi, Simon

we do update our products according to the customer needs on many parts including the PCB, but what do you want to dowith the PCB Assembly service, is it to assemble something by us? :)
By Ampleman Simon
#7038
Hello!

Yes, at the same time that you manufacture the PCB board, I would like to pay an extra amount to have some QFN parts soldered to the board and most of the 0402 and 0603 resistors, capacitors, inductors.

Is it something you can offer for small quantities (about 10 pcbs each time) on a regular basis ? If yes, can you give me an estimate of the cost involved ?

Thank you!

Simon
By Leff
#7063
Hi Ampleman,

sorry be late

we now are just provide the custom PCB service but not the assembling. Is that ok? :)
By ing.sohaib
#7285
Hi oggers,

Why do you need to wire the LEDs back to the panel, you’ll need only one connection to operate these. Exactly like the one wire temperature sensors work, in this case, just give a virtual/actual ground to all of them and control them using one connection each. I understand that even three wires coming from the panel will be cumbersome though. Best of luck with your experimentation though. Do update us if you find something important.