By fredeisen
#42542
Hi ,
On the Maqueen base there are male pinheaders, a group of 6pins and a group of 9 pins.
The 9 pins-group: signal pins are P0, P1 and P2 and their red-pins are unknown to me.
Where do these red-pins go?

The 6 pins-group on the other side: the red-pins is +5V . However their signal pins are unknown too.
In other words to which pins of the Microbit are these signal pins connected.

I like to connect a servo using the Arduino IDE.
Please can you help what they are?
Thanks and regards,
Fred
By nana.wang
#42553
Hi Fred,
Please check the MAQUEEN, the plate has a character "servo" printed, please connect wires correspondingly.
By fredeisen
#42722
Hi Nana,
I know how to connect the servos th the Maqueen plate.
My question is how to address the mentioned pins using the Arduino IDE.
What are the addresses of these pins?
Thanks and regards,
Fred
By nana.wang
#42747
Hi Fred,
You can just input pins of Maqueen to Arduino accordingly,
All pin numbers are printed in Maqueen. Well, red pins are just VCC, and green pins are signal pins.
And for IIC communication, here are examples for your reference.
Attachments
(8.81 KiB) Downloaded 182 times
By fredeisen
#42798
Hi Nana,
Thanks for the info.
From the info I assume that the 2 servo connection on the plate of the Maqueen Lite are addressable with 20 and 21 using the I2C interface.
I have a Maqueen Plus and another Huskylens on order.
Will the mentioned addreddes still vaild for the Maqueen Plus?
Thanks for your help.
Regards,
Fred
By nana.wang
#42806
Hi Fred,
Thank you for your support, the mentioned addreddes is not vaild for the Maqueen Plus.
We will prepare the other IIC communication example within 1 week.
Thank you for your consideration.
By fredeisen
#42953
Hi Nana,
The Maqueen Plus and Huskylens have arrived.
Playing with Mind+, for the Arduino IDE I need the library:
They are:
DFRobot_MaqueenPlus.h
DFRobot_Servo.h
DFRobot_NeoPixel.h
DFRobot_HuskyLens.h
Can yoy provide me that?
Thanks and regards,
Fred