DLP prints are somewhat sticky
Account cancelled 2019-09-06 02:33:35 2448 Views2 Replies Hello guys,
I'm new to 3d printing and it's really fun but the prints are kind of "sticky".
I'm using a photon from anycubic and their eco resin, it works fine. When the prints are done, I'm letting them "dry" a little and then washing them with a toothbrush and ethanol as recommended but they are still kind of sticky.
I don't really know what to do to get them really clean. I've tried water and soap before or after the ethanol, it's still the same.
What kind of solvant do you use to wash your prints ?
I'm new to 3d printing and it's really fun but the prints are kind of "sticky".
I'm using a photon from anycubic and their eco resin, it works fine. When the prints are done, I'm letting them "dry" a little and then washing them with a toothbrush and ethanol as recommended but they are still kind of sticky.
I don't really know what to do to get them really clean. I've tried water and soap before or after the ethanol, it's still the same.
What kind of solvant do you use to wash your prints ?
2020-06-05 22:32:21 rosapollard
mindgamesbackout wrote: ↑Thu Sep 05, 2019 6:33 pmHello guys,
I'm new to 3d printing and it's really fun but the prints are kind of "sticky".
I'm using a photon from anycubic and their eco resin, it works fine. When the prints are done, I'm letting them "dry" a little and then washing them with a toothbrush and ethanol as recommended but they are still kind of sticky.
I don't really know what to do to get them really clean. I've tried water and soap before or after the ethanol, it's still the same.
What kind of solvant do you use to wash your prints ?
rosapollard 