FAQ about Self-powered Wireless Switch (433Mhz) 【TEL0146】

userHead Yeez_B 2023-10-09 20:59:48 943 Views0 Replies

Q1: What jumper pads is need to solder for the switch to send messages on the push down/release.

A1: Please solder these two pads marked in the picture:



Q2: Which resistor is the bleed resistor

A2: The R2 and R4 are the bleed resistors in our schematic.




If you have other questions, just feel free to post them in our forum for consultation. We will reply them as soon as possible and improve the product FAQ gradually.