Introduction
DFRobot FireBeetle series are low power consumption controllers designed for Internet of Things (IoT) development. The
FireBeetle series are aiming straight at the point fast and convenient low-power IoT building. There are three categories of FireBeetle series, containing Boards (main control), Covers (expansion boards) and related Accessories.
FireBeetle LoRa 433MHz wireless transmission module adopts a high-performance chip SX127x LoRa 433MHz and with built-in PA (power amplifier) gain, compatible with Aruino. It supports long-range monitor, FSK modulation and the maximum transmission rate is 300K[null bps]. It also supports LoRaTM, the maximum transmission rate is 37.5Kbps. The circuit current is even lower than 0.2uA in the low power mode. It can be widely used in remote home automation detection, health monitoring and wearable device and so on.
NOTE: All parameters related to wireless signals in the same network should maintain consistency to avoid communication problems.
Specification
Operating Current: 3.3V
Operating Frequency: 433MHz
Modulation Type: LoRaTM
Output Power: ≤20dBm
Receiving Sensitivity: -139dBm
Emersion Current: ≤120mA
Receiving Current: ≤15mA
Sleep Current: ≤1uA
Transmission Power Range: -1dBm~20dBm(Maximum)
Transmission Mode: FIFO/ DMA
Operating Frequency: 403MHz~463MHz(typical value: 433MHz)
Transmission Range: 1 Km
Modulation Type: LoRaTM /FSK /GFSK /OOK
Built-in aerials offer good anti-jamming capacity
The Maximum RSSI is 127dB
FIFO Volume: 256bytes
Support CRC Frequency-hopping
SPI Interface
GPIO Interface: 5 (can be used as interruption)
Operating Temperature: -20℃~+70℃
Dimension: 58 x 29 mm/ 2.28 x 1.14 inches
Shipping List
FireBeetle Covers-LoRa Radio 433MHz x1
18pin-2.54mm Pin Header ×2
18pin-2.54mm Long Pin Header ×2
433MHz Spring Antenna – IPEX ×1
SMA-KE Antenna Connector ×1