Cellular Module / Mega IO Expansion Shield V2.4 / Mega 2560
Account cancelled 2017-01-27 17:45:35 1671 Views0 Replies Im having a hard time getting the following cellular module
http://nimbelink.com/skywire-4g-lte-cat-1
to work with the Mega IO Expansion Shield V2.4, and a MEGA2560.
Sky wire has an Arduino shield and a couple example programs here:
http://nimbelink.com/skywire-arduino-cellular-shield
I am using the SMS example, but cant seem to figure out what pins I should be using in my code.
I am using the XBEE2 slot on the expansion board (I belive its serial1). I dont know what pins to put in my program to control pin 20, 16, and 9 of the XBEE slot. Does the expansion board even connect all those pins, or are some not connected to anything?
http://nimbelink.com/skywire-4g-lte-cat-1
to work with the Mega IO Expansion Shield V2.4, and a MEGA2560.
Sky wire has an Arduino shield and a couple example programs here:
http://nimbelink.com/skywire-arduino-cellular-shield
I am using the SMS example, but cant seem to figure out what pins I should be using in my code.
I am using the XBEE2 slot on the expansion board (I belive its serial1). I dont know what pins to put in my program to control pin 20, 16, and 9 of the XBEE slot. Does the expansion board even connect all those pins, or are some not connected to anything?
