Topics

604 Views

0 Replies
Is it compatible with UNO? DFR0850 FAQ SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:24

562 Views

1 Replies
Pin Output and Pull-up FAQ DFR0652 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:24

792 Views

1 Replies
Can Lipo Charger-type C ( SKU: DFR0668 ) connected with Gravity: I2C 3.7V Li Battery Fuel Gauge ( SKU: DFR0563 ) ?Since i want to know the battery (lipo) remaining fuel (shown in t... FAQ DFR0668 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

956 Views

1 Replies
i have a problem with this sensor:Does it need to be peeled or opened or anything? because i dipped it underwater and received no reading. Double checked the UART 2 pins, rx to 16,... FAQ SEN0599 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

655 Views

1 Replies
Is there a 3D model of this case which you could share? FAQ FIT0949 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

781 Views

1 Replies
Can i confirm that the M.2 E Key slot is only 2230 and will not be able to fit 2280 SSDs like the Samsung 990 Pro? The pictures like like it may fit, so i am crossing my fingers he... FAQ DFR1141 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

1035 Views

1 Replies
Hello, I would like to know if the accuracy of the NO2 value at the output of the DFRduino UNO R3 (assembled with MICS-2714/SKU:SEN0441) is also 0.05ppm (like that of MICS-2714), o... FAQ SEN0441 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

869 Views

1 Replies
Hello, I’ve been tasked with purchasing an Odor Detector, specifically the ‘Fermion: MEMS Odor Smell Gas Detection Sensor (Breakout, 0.5-50ppm)’. However, I’m unable to determi... FAQ SEN0571 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

738 Views

1 Replies
Can this display be used on raspberry pi 4 model B FAQ FIT0955 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

939 Views

1 Replies
Can this sensor count people in a room? FAQ SEN0623 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

818 Views

1 Replies
I was wondering if the standoffs are removable? FAQ DFR0550-V2 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

522 Views

1 Replies
Dzień dobry,Czy silnik będzie działał na napięcie 3,3V? FAQ FIT0578 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:23

776 Views

1 Replies
Does it support an OV5640 camera? (5 million pixels) FAQ DFR0618 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

844 Views

1 Replies
Please tell me roughly when you are expecting more of these in stock. Thanks! FAQ DFR0430 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

651 Views

1 Replies
With many fake DS18B20 sensors on the market - does this one use a genuine Maxim sensor chip? FAQ SEN0511 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

947 Views

1 Replies
I am facing problem in memory card slot whnen ever i try to run the pogram its always saying initialization failed and i try a new one memory card I am facing the same problme but ... FAQ DFR0928 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

795 Views

1 Replies
Hi, do you have any sketch or python program for test or demo? FAQ SEN0588 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

551 Views

1 Replies
Does this sensor read oil? FAQ SEN0485 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

724 Views

1 Replies
Hello, in the product wiki, the following is mentioned: "RS485 requires 2 terminal resistors, and its resistance value must be equal to the characteristic impedance of the transmis... FAQ DFR0779 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

835 Views

1 Replies
We keep getting the output "bme begin failed, device not detected" I have checked the ICP addresses multiple times and tried different pins. FAQ SEN0335 SEO FAQ Aftersales FAQ JaneYu 2026-02-14 08:57:22

Topics

Trending