Page 2 of 2

Re: Problem loading sketch to Bluno

Unread postPosted:Wed Sep 24, 2014 2:50 am
by Grey.CC
Really? Uhm~ I'm afraid they dfrobot your mail.

It is [email protected]

Hey Willgllrm,

Could you tell me your mail address?

Anyway, I fix this issue after I uploaded a new bootloader to Atmega328p. It looks that the bootloader was broken when I updated a new firmware.

Re: Problem loading sketch to Bluno

Unread postPosted:Wed Sep 24, 2014 10:48 pm
by toby
Hi Grey,

I'm back with some good news. It bothered me that I was able to load a sketch one time but only once. So I kept playing with it. I connected a 9 volt supply to the Bluno and successfully loaded a sketch. Disconnect the 9 volt supply and it fails. Reconnect the supply and it succeeds. After programming, the Bluno runs fine with the USB cable supplying power but will not reliably write the flash. BTW - this is true using my Laptop and my deskside PC. Apparently, since writing flash requires additional power, the USB supplied power is marginal.

So maybe if others see the same problem and this will help them.

Thanks Grey.

Toby

Re: Problem loading sketch to Bluno

Unread postPosted:Thu Sep 25, 2014 2:38 am
by Grey.CC
Hi Toby,

Is there anything hot with the board? It looks like a power issue.
Have you try another USB cable?  Do you have a multimeter? Could you measure the voltage of Atmega328 chip
P3(GND) P4(VCC)