By kloom
#2211
Hello,
I'm wondering if it's possible to change the pairing code of the Bluetooth bee ?
http://www.dfrobot.com/index.php?route=product/product&filter_name=bluetooth&product_id=193

And in the best case to set it in an "auto-pairing" mode - like no code... ?

I've found nothing about this on this forum nor on the internet...

Someone already tried this ?

sincerly,

K.
By Hector
#2212
Hi Koom,


Here is the data sheet for the Bluetooth chip. In the data sheet there are some "AT" commands you can use to change the pairing pin.


[url=http://www.dfrobot.com/image/data/TEL0026/TEL0026_Datasheet.pdf]http://www.dfrobot.com/image/data/TEL0026/TEL0026_Datasheet.pdf[/url]
By kloom
#2213
Thanks ! I'll give a try to theses ATs... :)
Do you know why this BTBee is seen by my laptop (apple mac book pro 13") and not by an iphone nor an ipad ? I've read that the apple BT is limited... Is this pb come from Apple or my device config ?

Thanks for your time !

K.
By Hector
#2214
I'm not sure why your other idevices are not seeing the btbee...If your macbook sees the bee, then I would imagine the problem is an incompatibility with the ipad and iphone. But I can't be certain, since I don't have an iphone or ipad here to test with.